Case 35 — What a water-resistance claim does and does not establish
A listing describes a water-resistance rating but provides no test record for the individual watch. What evidence would address the gap?
Exercise RWF-31231/35: address this question within its stated limits.
Case 10 — Comparing versions without mixing case sizes
Correction note for “Comparing versions without mixing case sizes”: retain the wording beginning “Match reference, dimensions and…” in the record. If later material changes it, add the date, the changed wording and the source for that change; do not invent a completed correction here. Keep the stated question separate from any broader claim.
Case 45 — Case finishing: distinguish a reflection from a surface mark · source wording exercise
Method note for “Case finishing: distinguish a reflection from a surface mark”: use “A mark should be assessed across multiple views; aggressive polishing…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Retain the source wording beside any paraphrase.
Case 5 — Crown operation: when a forum cannot diagnose the resistance
Method note for “Crown operation: when a forum cannot diagnose the resistance”: use “Describe whether resistance occurs during winding or setting and…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Keep the stated question separate from any broader claim.
Clarification for “Forum comparison archive: link the evidence and the correction”: the point beginning “Add a dated correction near the original conclusion…” belongs to the question as written. It should not be read as a report that a new check, purchase or experiment has been completed. Review focus: scope. Keep the stated question separate from any broader claim.
Limit of the answer in “Clasp photographs: what to request before judging alignment”: “Request open and closed views from both sides,…” is an excerpt from the discussion, not an independent verification. A reader needs the relevant original material before treating an interpretation as established. Review focus: scope. Keep the stated question separate from any broader claim.
Record lug-to-lug and the effective span including rigid end links. Use a similar camera distance and neutral wrist position; photographs support fit discussion but do not replace measurements.
Case 2 — Strap dimensions: lug width, taper, thickness and spring bar diameter explained
Lug width is the essential one: the inside distance between the lugs where the strap fits. Measure with a ruler marked in millimetres, ideally reading it under magnification. Most watches use even numbers (18, 20, 22mm), but odd widths exist. If you measure 19 or 21, measure again and check the manufacturer spec before ordering.
No single lighting setup settles that question. Compare multiple controlled angles and describe the visible observation without asserting material specifications that have not been verified.
Case 16 — Lug-to-lug and end-link overhang in wrist photographs
Record lug-to-lug and the effective span including rigid end links. Use a similar camera distance and neutral wrist position; photographs support fit discussion but do not replace measurements.
On anti-reflective coatings: inner-surface AR cuts glare without wear concerns. Outer-surface AR improves legibility further but can scuff over time, and the scuffs show up as hazy patches in certain light. When comparing two watches, check which surfaces are coated. Spec sheets often just say 'AR coated' without saying where.
State the lighting and white-balance limitations. Compare controlled images where available and avoid calling a colour defect from differently processed photographs.
Summary draft for “Packing photographs: document condition without exposing an address”: the answer addresses “Photograph the item and protective packing…”; the related point is “Remove names, addresses, barcodes and tracking tokens from public…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: scope. Keep the stated question separate from any broader claim.
Case 17 — Case finishing: distinguish a reflection from a surface mark
Correction note for “Case finishing: distinguish a reflection from a surface mark”: retain the wording beginning “Ask for photographs with the light moved and…” in the record. If later material changes it, add the date, the changed wording and the source for that change; do not invent a completed correction here. Keep the stated question separate from any broader claim.
Case 20 — Model comparison: dive bezel action and alignment, how to compare fairly
Summary table proposal: click count, back-play (none, slight, noticeable), click consistency around the rotation, and alignment (straight-on photo, offset in fractions of a click). With that, the thread can compare actual properties instead of trading adjectives. Dated corrections welcome below.