Case 6 — Packing photographs: document condition without exposing an address
Summary draft for “Packing photographs: document condition without exposing an address”: the answer addresses “Photograph the item and protective packing…”; the related point is “Remove names, addresses, barcodes and tracking tokens from public…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: scope. Keep the stated question separate from any broader claim.
Suggested protocol. 1) Both dials in one frame. 2) Diffuse daylight, no direct sun, plus a second shot under neutral indoor light. 3) Grey card visible. 4) No filters, no editing. 5) State camera settings if known. If both shots show the same direction of difference, the claim is supported. If the difference flips between lighting conditions, it's most likely lighting.
Case 36 — Date window centring: compare the same date at the same angle
Clarification for “Date window centring: compare the same date at the same angle”: the point beginning “Use the same numeral, camera axis…” belongs to the question as written. It should not be read as a report that a new check, purchase or experiment has been completed. Review focus: scope. Keep the stated question separate from any broader claim.
Suggested protocol. 1) Both dials in one frame. 2) Diffuse daylight, no direct sun, plus a second shot under neutral indoor light. 3) Grey card visible. 4) No filters, no editing. 5) State camera settings if known. If both shots show the same direction of difference, the claim is supported. If the difference flips between lighting conditions, it's most likely lighting.
Add lug-to-lug, thickness and lug width as separate rows. Diameter alone tells you little about wearability. Two cases 2mm apart in diameter can be within 1mm of each other lug to lug, and that number decides whether the watch overhangs a small wrist. Also give the source for each figure: manufacturer sheet, caliper measurement, or catalogue listing.
Case 10 — Magnetism and rate: record evidence before naming a cause
A sudden rate change is being attributed to magnetism without a measurement. How should the discussion be structured?
Exercise RWF-22126/10: address this question within its stated limits.
Case 30 — Lume comparison: keep exposure and charging conditions consistent
Two glowing dials are shown with different camera exposure and unknown charging time. What can the images establish?
Exercise RWF-19829/30: address this question within its stated limits.
Case 17 — Service enquiry: information a watchmaker can use
Method note for “Service enquiry: information a watchmaker can use”: use “Document when it stops, winding behaviour, recent impacts and…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Keep the stated question separate from any broader claim.
Case 55 — Comparing versions without mixing case sizes · source wording exercise
Correction note for “Comparing versions without mixing case sizes”: retain the wording beginning “List confirmed differences separately from seller descriptions and date the comparison…” in the record. If later material changes it, add the date, the changed wording and the source for that change; do not invent a completed correction here. Retain the source wording beside any paraphrase.
Case 2 — Strap dimensions: lug width, taper, thickness and spring bar diameter explained
A notation like 20/16 means 20mm at the lugs, tapering to 16mm at the buckle. Taper affects look and comfort more than fit. A strong taper suits smaller and dressier cases, a straight strap suits sport watches. Your buckle or clasp also has to match the narrow end, so check that if you want to reuse an existing buckle.
Case 26 — Accuracy expectations: is -8 s/d acceptable on an entry-level automatic?
Start with how you measured it. Comparing against a phone clock once a day for a week, at the same time, and noting the offset is reliable enough. One 24-hour reading isn't, because rate depends on wrist time, position overnight and state of wind. Average across several days before deciding anything.
Case 17 — Maintenance question: how do I tell if an automatic actually needs service?
A sudden rate change has several possible causes. Ask a watchmaker to test suspected magnetism rather than diagnosing it from a compass or attempting an adjustment based on forum replies.
Case 41 — Bracelet fit: measuring the usable clasp adjustment · source wording exercise
Correction note for “Bracelet fit: measuring the usable clasp adjustment”: retain the wording beginning “Request the closed bracelet circumference rather than inferring…” in the record. If later material changes it, add the date, the changed wording and the source for that change; do not invent a completed correction here. Retain the source wording beside any paraphrase.
Case 10 — Bracelet fit: measuring the usable clasp adjustment
A nominal case diameter says little about a bracelet that cannot be shortened enough. How should a sizing question be documented?
Exercise RWF-10194/10: address this question within its stated limits.
Case 5 — Shipping timeline: separate dispatch, handover and scan events
Summary draft for “Shipping timeline: separate dispatch, handover and scan events”: the answer addresses “Distinguish label creation from physical acceptance and retain dated…”; the related point is “Ask the sender or carrier for clarification; missing scans alone…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: scope. Keep the stated question separate from any broader claim.