Case 111 — Lug-to-lug and end-link overhang in wrist photographs · documentation exercise
A wide-angle wrist photo exaggerates the nearest edge of the case. How can two watches be compared fairly?
Review focus: documentation. Distinguish an original record from a proposed record format. Use the original answer fragment “Use a similar camera distance and neutral wrist position; photographs support…” as the discussion anchor; no new event or result is supplied.
Exercise RWF-28278/111: address this question within its stated limits.
Case 10 — Disputed observation: is this dial colour shift real or just lighting?
Suggested protocol. 1) Both dials in one frame. 2) Diffuse daylight, no direct sun, plus a second shot under neutral indoor light. 3) Grey card visible. 4) No filters, no editing. 5) State camera settings if known. If both shots show the same direction of difference, the claim is supported. If the difference flips between lighting conditions, it's most likely lighting.
Clarification for “Packing photographs: document condition without exposing an address”: the point beginning “Photograph the item and protective packing…” belongs to the question as written. It should not be read as a report that a new check, purchase or experiment has been completed. Review focus: source wording. Retain the source wording beside any paraphrase.
Case 2 — Maintenance question: how do I tell if an automatic actually needs service?
A sudden rate change has several possible causes. Ask a watchmaker to test suspected magnetism rather than diagnosing it from a compass or attempting an adjustment based on forum replies.
Case 27 — What a water-resistance claim does and does not establish
Correction note for “What a water-resistance claim does and does not establish”: retain the wording beginning “Ask a qualified watchmaker about a suitable test for that individual…” in the record. If later material changes it, add the date, the changed wording and the source for that change; do not invent a completed correction here. Keep the stated question separate from any broader claim.
Case 29 — Comparing versions without mixing case sizes
Two purported versions differ in case diameter and bracelet. How can the comparison avoid attributing every difference to a revision?
Exercise RWF-20916/29: address this question within its stated limits.
Method note for “Lume comparison: keep exposure and charging conditions consistent”: use “Repeat with equal light source, charging duration, elapsed time and camera…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Keep the stated question separate from any broader claim.
Case 26 — First QC request: the minimum useful information
Correction note for “First QC request: the minimum useful information”: retain the wording beginning “State the model configuration, the specific concern and…” in the record. If later material changes it, add the date, the changed wording and the source for that change; do not invent a completed correction here. Keep the stated question separate from any broader claim.
Case 5 — Reading a timegrapher recording without losing the context
Summary draft for “Reading a timegrapher recording without losing the context”: the answer addresses “Keep the complete recording and ask for the…”; the related point is “A single number cannot establish service condition, movement identity…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: scope. Keep the stated question separate from any broader claim.
Case 13 — Model comparison: dive bezel action and alignment, how to compare fairly
Summary table proposal: click count, back-play (none, slight, noticeable), click consistency around the rotation, and alignment (straight-on photo, offset in fractions of a click). With that, the thread can compare actual properties instead of trading adjectives. Dated corrections welcome below.
Correction note for “QC photographs: perspective or a genuinely tilted index?”: retain the wording beginning “Request a level straight-on image with the hands…” in the record. If later material changes it, add the date, the changed wording and the source for that change; do not invent a completed correction here. Keep the stated question separate from any broader claim.
Thickness matters more than people expect. Straps around 4 to 5mm at the lugs can hit the case or stop the strap folding down on watches with short lugs or tight lug-to-case clearance. Do you know whether your watch has drilled lugs or a tight gap between strap and case? That tells you how much thickness is safe.
Request a level straight-on image with the hands clear of the marker. Compare two independently aligned images before drawing a conclusion; an overlay cannot correct an oblique camera angle.
Case 6 — Lug-to-lug and end-link overhang in wrist photographs
Clarification for “Lug-to-lug and end-link overhang in wrist photographs”: the point beginning “Record lug-to-lug and the effective span…” belongs to the question as written. It should not be read as a report that a new check, purchase or experiment has been completed. Review focus: scope. Keep the stated question separate from any broader claim.
Summary draft for “Comparing dial colour under different lighting”: the answer addresses “State the lighting and…”; the related point is “Compare controlled images where available and avoid calling a…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: scope. Keep the stated question separate from any broader claim.