Case 9 — Case finishing: distinguish a reflection from a surface mark
Summary draft for “Case finishing: distinguish a reflection from a surface mark”: the answer addresses “Ask for photographs with the light moved and…”; the related point is “A mark should be assessed across multiple views; aggressive polishing…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: scope. Keep the stated question separate from any broader claim.
Case 200 — QC photography: what photos actually help verify a pre-owned listing? · correction exercise
Method note for “QC photography: what photos actually help verify a pre-owned listing?”: use “Compare against a known-good reference image of the…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Preserve the old wording if a later source changes the interpretation.
Clarification for “Clasp photographs: what to request before judging alignment”: the point beginning “Request open and closed views from both sides,…” belongs to the question as written. It should not be read as a report that a new check, purchase or experiment has been completed. Review focus: scope. Keep the stated question separate from any broader claim.
Case 14 — Maintenance question: how do I tell if an automatic actually needs service?
Common advice says service every five years, but service is expensive and some people run watches much longer. What observable signs actually indicate a mechanical watch needs attention, as opposed to just being due on a calendar?
Exercise RWF-23428/14: address this question within its stated limits.
Case 17 — Lume questions: why does my lume fade so quickly, and how should I compare it?
Clarifying question: how are you charging it? A few seconds under a warm indoor bulb gives a much weaker charge than daylight or a UV source. Many 'weak lume' reports turn out to be undercharging. Try a consistent charge, such as 30 seconds under a phone flashlight at a fixed distance, before judging.
Case 35 — Bracelet fit: half-links, micro-adjust holes and the 'between sizes' problem
A correction to a common assumption: a slightly loose fit isn't automatically wrong. Heavier heads tend to slide on loose bracelets, but a lighter watch often wears comfortably with a finger's width of space. Try 'loose' for a full day before deciding it doesn't work. Comfort over hours tells you more than the first minute.
Case 22 — Model comparison: dive bezel action and alignment, how to compare fairly
Separate three properties: click count (60 or 120 positions), feel (how firm each click is, and whether there's back-play), and alignment (whether the pip lines up with the 12 o'clock marker at rest). Crisp vs mushy is mostly about feel and back-play. Alignment can be measured, so treat it separately.
Case 2 — Movement identification: the limits of a rotor photograph
Limit of the answer in “Movement identification: the limits of a rotor photograph”: “Describe visible bridge shapes and markings separately…” is an excerpt from the discussion, not an independent verification. A reader needs the relevant original material before treating an interpretation as established. Review focus: scope. Keep the stated question separate from any broader claim.
Case 4 — Lume questions: why does my lume fade so quickly, and how should I compare it?
A bright initial glow followed by a steep drop is normal for photoluminescent pigments. Afterglow fades fastest in the first minutes and then settles to a dim, long-lasting level that dark-adapted eyes can still read. The real question is whether it's readable after an hour in darkness, not how it looks right after charging.
A caution: photos can't settle everything. Water resistance, timekeeping and internal condition aren't visible in any image. A short timegrapher video or a stated recent rate test adds information, but treat it as a seller claim unless an independent party confirms it. Photos narrow the risk. They don't remove it.
Case 24 — Case finishing: distinguish a reflection from a surface mark
Ask for photographs with the light moved and retain the same viewing angle. A mark should be assessed across multiple views; aggressive polishing is not an appropriate diagnostic test.
Case 9 — Service enquiry: information a watchmaker can use
Limit of the answer in “Service enquiry: information a watchmaker can use”: “Document when it stops, winding behaviour, recent impacts and…” is an excerpt from the discussion, not an independent verification. A reader needs the relevant original material before treating an interpretation as established. Review focus: scope. Keep the stated question separate from any broader claim.
Keep the complete recording and ask for the settings, winding state and position. A single number cannot establish service condition, movement identity or performance on a wrist.
Case 18 — Bracelet fit: measuring the usable clasp adjustment
Summary draft for “Bracelet fit: measuring the usable clasp adjustment”: the answer addresses “Record wrist circumference, removable links and the clasp…”; the related point is “Request the closed bracelet circumference rather than inferring…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: scope. Keep the stated question separate from any broader claim.
Case 39 — Movement identification: the limits of a rotor photograph · source wording exercise
Method note for “Movement identification: the limits of a rotor photograph”: use “Ask a qualified watchmaker to inspect it if identification matters for…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Retain the source wording beside any paraphrase.