Case 30 — Lume questions: why does my lume fade so quickly, and how should I compare it?
A practical test without a camera: charge both watches the same way, sit in a dark room, and check readability at 5 minutes, 30 minutes and 2 hours. Write down which you can still read the time on. It's subjective but repeatable, and more useful than a single photo.
Start with how you measured it. Comparing against a phone clock once a day for a week, at the same time, and noting the offset is reliable enough. One 24-hour reading isn't, because rate depends on wrist time, position overnight and state of wind. Average across several days before deciding anything.
Case 126 — Beginner glossary Q&A: complication, caliber, jewel count, power reserve · documentation exercise
Summary draft for “Beginner glossary Q&A: complication, caliber, jewel count, power reserve”: the answer addresses “It doesn't tell you how well that…”; the related point is “A complication is any function beyond…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: documentation. Distinguish an original record from a proposed record format.
A useful table has columns for date, position, winding state, lift angle, rate, amplitude and beat error. Keep the full recording so settings and stability can be checked.
For a two-watch comparison, the practical order is usually case dimensions first, then power reserve if you rotate, then caliber for serviceability. Jewel count comes last. Complications only matter if you'll use them. Can you say what the two candidates are, in generic terms like 'dive style vs dress style'? The priorities shift a lot between those.
Case 10 — Maintenance question: how do I tell if an automatic actually needs service?
Common advice says service every five years, but service is expensive and some people run watches much longer. What observable signs actually indicate a mechanical watch needs attention, as opposed to just being due on a calendar?
Exercise RWF-21920/10: address this question within its stated limits.
Case 41 — Bracelet fit: half-links, micro-adjust holes and the 'between sizes' problem · source wording exercise
Summary draft for “Bracelet fit: half-links, micro-adjust holes and the 'between sizes' problem”: the answer addresses “Fit often improves by moving one link from the 6 o'clock…”; the related point is “That doesn't change length, but it shifts where the clasp sits…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: source wording. Retain the source wording beside any paraphrase.
Case 22 — Bracelet fit: half-links, micro-adjust holes and the 'between sizes' problem
Micro-adjust spacing varies by clasp. Measure the actual change at each setting rather than assuming a standard number of millimetres; compare the usable range with the link length.
Case 21 — Accuracy expectations: is -8 s/d acceptable on an entry-level automatic?
One method that often helps without any service is using overnight resting position to cancel daily drift. Many watches gain in some positions and lose in others. If yours loses on the wrist, try leaving it crown up or dial up overnight and log the result for a few nights. Some people get close to zero this way.
Micro-adjust spacing varies by clasp. Measure the actual change at each setting rather than assuming a standard number of millimetres; compare the usable range with the link length.
Method note for “Strap compatibility: width is only the first measurement”: use “Measure the lug opening and document bar diameter,…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Retain the source wording beside any paraphrase.
Case 33 — Lume questions: why does my lume fade so quickly, and how should I compare it?
Use a consistent charge, fixed exposure and several elapsed-time observations. Record readability and the conditions rather than applying an unsupported universal fade-time threshold.
The difficulty is that phone cameras adjust white balance automatically, and blue dials are especially sensitive. Two photos of the same dial under different light can easily look like a 'batch difference'. Any comparison needs both dials in the same frame, under the same light, ideally next to a neutral grey or white reference card.
Case 10 — What a water-resistance claim does and does not establish
Ask a qualified watchmaker about a suitable test for that individual case and record the test date and method. A photograph or a caseback engraving is not proof of water resistance.
Method note for “Case finishing: distinguish a reflection from a surface mark”: use “Ask for photographs with the light moved and…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Keep the stated question separate from any broader claim.