Lug width is the essential one: the inside distance between the lugs where the strap fits. Measure with a ruler marked in millimetres, ideally reading it under magnification. Most watches use even numbers (18, 20, 22mm), but odd widths exist. If you measure 19 or 21, measure again and check the manufacturer spec before ordering.
Forum Replies Created
Clarification for “Forum comparison archive: link the evidence and the correction”: the point beginning “Add a dated correction near the original conclusion…” belongs to the question as written. It should not be read as a report that a new check, purchase or experiment has been completed. Review focus: scope. Keep the stated question separate from any broader claim.
Clarification for “Reading a timegrapher recording without losing the context”: the point beginning “Keep the complete recording and ask for the…” belongs to the question as written. It should not be read as a report that a new check, purchase or experiment has been completed. Review focus: scope. Keep the stated question separate from any broader claim.
Case 6 — Model comparison: dive bezel action and alignment, how to compare fairly
On alignment, a clarifying point: is the misalignment visible straight on, or only from an angle? Parallax on a raised bezel can make a perfectly aligned pip look half a click off when viewed slightly from the side. Photograph straight above the dial before calling it misaligned.
Case 10 — Crystal reflections: why a dark patch is not a coating test
A dark area appears at an oblique angle in a single photograph. Does that establish a coating difference?
Exercise RWF-24433/10: address this question within its stated limits.
Case 7 — Accuracy expectations: is -8 s/d acceptable on an entry-level automatic?
Log the rate over several comparable days, identify the correct specification and state the conditions. Stable and changing patterns raise different questions; a watchmaker can assess whether regulation, inspection or no action is appropriate.
Method note for “Service enquiry: information a watchmaker can use”: use “Document when it stops, winding behaviour, recent impacts and…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Keep the stated question separate from any broader claim.
Case 48 — Date window centring: compare the same date at the same angle · source wording exercise
Different numerals have different optical centres. A comparison mixes two dates and unequal magnification. How can the evidence be improved?
Review focus: source wording. Retain the source wording beside any paraphrase. Use the original answer fragment “Keep the uncropped originals alongside the detail crops and distinguish…” as the discussion anchor; no new event or result is supplied.
Exercise RWF-19445/48: address this question within its stated limits.
Jewel count describes bearings used in a movement design; it is not a quality ranking. Compare the documented movement architecture and service support rather than assuming a higher count makes one watch better.
Case 2 — QC photography: what photos actually help verify a pre-owned listing?
A caution: photos can't settle everything. Water resistance, timekeeping and internal condition aren't visible in any image. A short timegrapher video or a stated recent rate test adds information, but treat it as a seller claim unless an independent party confirms it. Photos narrow the risk. They don't remove it.
Describe whether resistance occurs during winding or setting and whether the crown engages consistently. Stop forcing it and arrange inspection rather than trying an unverified repair from a thread.
Case 10 — Beginner glossary Q&A: complication, caliber, jewel count, power reserve
One more term that will come up is 'hacking', meaning the seconds hand stops when you pull the crown so you can set the time to the second. It's minor, but beginners often assume every automatic has it, and not all do. That rounds out the glossary: caliber means what, complication means extra functions, jewels mean bearings, power reserve means how long it runs, hacking means precise setting.
Case 3 — Seller review template: facts, dates and unresolved questions
What belongs in a useful review template when no actual purchase experience is being asserted?
Exercise RWF-13522/3: address this question within its stated limits.
Case 38 — Bracelet fit: half-links, micro-adjust holes and the 'between sizes' problem · source wording exercise
Summary draft for “Bracelet fit: half-links, micro-adjust holes and the 'between sizes' problem”: the answer addresses “Fit often improves by moving one link from the 6 o'clock…”; the related point is “That doesn't change length, but it shifts where the clasp sits…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: source wording. Retain the source wording beside any paraphrase.
Case 23 — Clasp photographs: what to request before judging alignment
Correction note for “Clasp photographs: what to request before judging alignment”: retain the wording beginning “Request open and closed views from both sides,…” in the record. If later material changes it, add the date, the changed wording and the source for that change; do not invent a completed correction here. Keep the stated question separate from any broader claim.