Case 70 — Crystal types: sapphire, mineral and acrylic trade-offs for daily wear · source wording exercise
Summary draft for “Crystal types: sapphire, mineral and acrylic trade-offs for daily wear”: the answer addresses “Sapphire is very hard to scratch but can chip or crack…”; the related point is “Acrylic scratches easily but flexes, rarely shatters, and light scratches…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: source wording. Retain the source wording beside any paraphrase.
Summary draft for “Bracelet fit: measuring the usable clasp adjustment”: the answer addresses “Request the closed bracelet circumference rather than inferring…”; the related point is “Record wrist circumference, removable links and the clasp…”. Keep both connected to the opening question, and mark any conclusion needing further records as unresolved. Review focus: scope. Keep the stated question separate from any broader claim.
Clarifying question: how are you charging it? A few seconds under a warm indoor bulb gives a much weaker charge than daylight or a UV source. Many 'weak lume' reports turn out to be undercharging. Try a consistent charge, such as 30 seconds under a phone flashlight at a fixed distance, before judging.
Use fields for order date, promised terms, dated communications, delivery evidence and resolution. Leave unsupported fields blank and separate observations from opinions; this reference is not a seller endorsement.
Limit of the answer in “Model comparison: dive bezel action and alignment, how to compare fairly”: “Crisp vs mushy is mostly about…” is an excerpt from the discussion, not an independent verification. A reader needs the relevant original material before treating an interpretation as established. Review focus: scope. Keep the stated question separate from any broader claim.
Case 5 — Seller review template: facts, dates and unresolved questions
Use fields for order date, promised terms, dated communications, delivery evidence and resolution. Leave unsupported fields blank and separate observations from opinions; this reference is not a seller endorsement.
Regulation is possible if you want it closer. On many movements it's a quick adjustment by a watchmaker. Can you check whether the losing rate is consistent or getting worse? A stable -8 is a good candidate for simple regulation. A growing loss points to something else, such as falling amplitude, and regulation alone won't fix that.
Case 23 — Magnetism and rate: record evidence before naming a cause
A sudden rate change is being attributed to magnetism without a measurement. How should the discussion be structured?
Exercise RWF-20169/23: address this question within its stated limits.
Case 9 — Lug-to-lug and end-link overhang in wrist photographs
A wide-angle wrist photo exaggerates the nearest edge of the case. How can two watches be compared fairly?
Exercise RWF-19200/9: address this question within its stated limits.
Case 13 — Comparison thread: 38mm vs 40mm versions of the same field watch, with a dated correction log
Add lug-to-lug, thickness and lug width as separate rows. Diameter alone tells you little about wearability. Two cases 2mm apart in diameter can be within 1mm of each other lug to lug, and that number decides whether the watch overhangs a small wrist. Also give the source for each figure: manufacturer sheet, caliper measurement, or catalogue listing.
Case 23 — Comparing dial colour under different lighting
Limit of the answer in “Comparing dial colour under different lighting”: “State the lighting and…” is an excerpt from the discussion, not an independent verification. A reader needs the relevant original material before treating an interpretation as established. Review focus: scope. Keep the stated question separate from any broader claim.
Power reserve is how long the watch runs from full wind until it stops. It matters if you rotate watches: a 38-hour reserve may stop over a weekend off the wrist, while 70-plus hours may not. One clarifying point is that rate stability often gets worse near the end of the reserve, so the full figure is not all precision-grade running time.
Start with function, legibility, assembly and clear visible damage. Explain what the full-size image shows, what the crop adds and what remains uncertain; do not turn an overlay into an automatic verdict.
Summary order of importance. 1) Lug width, measured between the lugs. 2) Lug-end thickness against clearance. 3) Spring bar diameter. 4) Taper and buckle width. 5) Length, which is usually given as long side / short side in mm and should be compared with a strap that already fits you.
Case 37 — Packing photographs: document condition without exposing an address · source wording exercise
Method note for “Packing photographs: document condition without exposing an address”: use “Remove names, addresses, barcodes and tracking tokens from public…” as a row heading in a proposed working record. Put the statement, its supporting source or measurement, and any unresolved detail in separate fields. This proposes a format; it supplies no additional evidence. Retain the source wording beside any paraphrase.