Skip to content
RepWatchForumSign in

Timegrapher reading context: what do rate, amplitude and beat error actually tell me? · RWF-13035

Viewing 2 posts - 1 through 2 (of 2 total)
QCReader 09764Participant
#1

I ran a watch on a basic timegrapher and got +6 s/d, 245 degrees amplitude and 0.8 ms beat error, dial up, about an hour after winding. Is this good, bad or normal? I don't want to send it for service on a single reading.

Reply scope: address the opening question, explain the supporting record or reasoning, and state the limit of the answer.

#2

First identify the caliber, lift-angle setting, winding state and measurement position. Without those fields, the rate, amplitude and beat-error values lack enough context for a useful comparison.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.